To Finish or not to finish, that’s the question?

Our guitar Heroes have lived and died and this circle of life are also apparent in old instruments.

The word refinish have two meanings in the romantic sense. You have the Re-finish. This part is rebirth, making new, giving new life to something old. The re-finish part means done, to part with the old. This takes the scars and nicks and dents away that we have imparted so diligently in our journey together as master and instrument.

If a client has an old guitar and asked you to refinish his guitar, what do you say?

This question has come up a lot. The problem is value versus appearance.

It is not an easy answer. There are many things to consider. First, Condition then age, colour, finish, year, make and value are some considerations. Many times someone already started to sand or chemically take the old finish off. If that’s the case I would consider a refinish. Finish change colour with exposure to the UV in the sun. This can be difficult to control. Modern finishes are much more protected against UV rays.

Blue becomes green, red becomes orange. To predict how the colour will change is extremely difficult. When the paint dries, it will also turn a few shades darker.  You can finish an old Guitar in amber, just like it would look now after 40 years. Just to see it again in a few years looking terrible. 1k finish is usually a resin that dries with evaporation.2k finish has a resin and a catalyst that forms a chemical reaction that hardens in 24 hours. UV curable finish has a resin and chemical hardener that reacts with the suns rays. It’s normally light in the spectrum from 490 to about 640. These are the basis of most finishes.

To start off, first you have to remove the old finish. It can be done in two ways .The first one is chemical and the other is sanding from coarse to fine until all the old Lacquer is gone. Chemical stripper is often used and the ammonia inside the stripper dries the wood out. This will change the cells and can cause cracks later. Sanding has its own drawbacks. If you sand the old finish of, you will remove some wood as well. This will change the stiffness of the top. If the top has a fine grain, this is called season rings or year rings. The distance between winter and summer growth will be very close to each other. The wider apart they are the less stiff the top will be. The thickness also affects the stiffness and this can change the sound that drew you to the guitar in the first place. It is important to take all of this in consideration. To start the finishing of the guitar, you will have to lay down a good foundation. We call this the base coat; this can be a sealer coat, made up of thinned finish. The second stage will be a colour coat which should be even and thin. After that you will seal the colour coat with one or more clear coats.

Sanding the surface with soft wet and dry sandpaper from 320 up to 1500 word and then buffing the finish to a full gloss. It is hard to get all the steps right, but with practice it can be very satisfying.

I cannot wait for next week’s blog. See you soon.